DX12S Dispersor-XS spreader 7/8 to 1oz wad 12ga (2500/bulk case)
This is the all new lighter version of the Dispersor-X. It is ideal for close-range shots of 5-25 yards with lighter loads of 7/8 oz to 1 oz lead shot. The integrated X-shaped spreader device molded directly into the shotcup provides shooters with even pellet distribution. Its G-type crush section reduces felt recoil in the 12-gauge while allowing a variety of load height adjustments. The pegged dome gas seal effectively distributes fast burn rate powders. Use of an overshot card (we like the #COS12 Clear Overshot Disc) helps create a bit of compression which will produce an even pattern distribution.
| Click to save: buy in case quantity |
Identifying features: The DX12S dimensions are nearly identical to those of the original DX12, with one important difference. Note the 24 pins that protrude down from the gas seal in a two circular designs around one central pin (see image above). These pins occupy space that would otherwise be filled with propellant, thus lifting the wad above the propellant charge. This change results in approximately a 1/4" increase in wad height in the hull.Curmudgeon's Loading Tip: If you are using a MEC reloader, their Steel Shot Rammer Tube #1308436 fits perfectly around the X-shaped spreader of the Dispersor-X 12ga wad. Very slick loading!
- Shot cup body = 1.504"
- Diameter = 0.715"
- Thickness = 0.035"
- Shot cup depth = 0.910"
- Gas seal = 0.275" pin-stacked obturator
Product Type: Spreader wad, preslit with two slits.
Typical Loads: 7/8 oz lead to 1 oz lead
Maximum Payload: 1 oz lead
Made in Italy