Cheddite .410 2-1/2" new primed hull (case 5500)
These are true .410 hulls according to SAAMI specifications. The maximum body diameter, which is slightly wider than CIP European standards, They are stamped .410 on the head.
- 8mm brass
- Skived tube (taped material at the top of the hull)
- Cheddite 209 Primer
- Headstamp: "Cal. 36"
- Mfg by Cheddite
If cartridge manufacturers do not produce their own hulls, it is highly likely that they are using Cheddite hulls. These are reliable straight-wall hulls; extremely versatile for almost all load types. They crimp easily, either with a fold or roll. Primed with the reliable CX2000 (known as the Cheddite-209 in the USA).
A Super Crown Crimp Starter will make your crimping easier with much more satisfying results. Improved crimps and more complete powder ignition will result.
Remember, new/primed hulls are your best value and there's never a Hazmat charge when you ship them via ground service in the contiguous U.S.
Load data: See our Small Bore Manual both for lead & nontoxic loads, including buckshot loads for some .410 handguns.
|Comparison Chart: .410 2-1/2" and 3" hulls|
|*Select an alternative if your first choice is out of stock.|
Made in France