Paradox Expander Red Star Slug 12ga (valu-pak/50)


Paradox Expander Red Star Slug 12ga (valu-pak/50)
Item Number: 0141211
  Be the first to review this item
$43.50
In Stock
Quantity 


 WARNING: This product can expose you to chemicals including lead, which are known to State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65warnings.ca.gov

Detailed Description

Paradox Expander Red Star Slug 12ga (valu-pak/50)

Paradox is known all over Europe and Asia for their brilliant slug designs. The Red Star Slug is a medium piercing slug which is designed to mushroom upon impact. The plastic star implant drives into the mass of the slug to create the expansion effect. Superb center of gravity of high accuracy and stability.

Dimensions:

OAL = 1.656" (42.07 mm)
Length, slug only = .826" (20.98 mm)
Diam, slug = .728" (18.51 mm)
Gas Seal = .739"

Product Type: Slug, lead, with molded plastic carrier
Size: 12-gauge 1 oz (433 grains) lead slug and carrier (45 grains) = 480 grains total
Type: Flat-nose hollow-point lead

*Industry-accepted tolerances apply to all weights and measures.

WARNING: Spire tip slugs placed within a tube magazine (i.e. pump or auto shotguns) must not have any protrusions from the crimp. Although it is unlikely, it is possible that the tip of the protruding slug could impact the primer of the shell in front of it. This could be extremely dangerous. A pointed slug should be covered with a cardboard or plastic disc or even fold-crimped. Failing that, the shotgunner should only place one slug at a time in a tube magazine. Verify no slug, regardless of type, protrudes past the top of a hull.

When loading slug components with an inherent gas seal, the entire slug component must be nudged down with your reloading press' rammer tube. Many loaders complain that they don't have enough room for a crimp. This tells us that the reloader is NOT pushing down on the slug prior to crimping and thus not properly seating the slug on the powder. Depending on your loading tool, these loads may require a series of nudges to allow the powder to enter and fill the concave (cupped) plastic gas seal. If you don't do this, then you'll get the "no-fit" problem or a failed load when the powder refuses to fully ignite. Burned or punctured gas seals is almost always a result of this user error.

Made in Turkey