Paradox Expander Sabot Slug (only) 12ga (Valu-Pak/50)

Paradox Expander Sabot Slug 12ga .50" (Valu-Pak/50)

Out of Turkey comes a new entry into some of our ballistic lab's favorite slugs. Paradox is known all over Europe and Asia for their brilliant slug designs.

The Expander Sabot weighs in at 332 grains and .50" caliber expansion tip bullet. This kit also comes with the Paradox cushioned gas seal and cushion support wad.

This is our valu-pak of fifty sabots and bullets ONLY. This package does not come with the Paradox cushioned gas seal or cushioned support wad. The BPI lab will be developing loads for this sabot and bullet with our FS12 and BRP-12 cushioned support wads.

Dimensions:

OAL (bullet in sabot = 1.244" (31.59 mm)
Length, sabot only = 1.135" (28.82 mm)
Length, bullet only = 1.073" (27.27 mm)
Diam, bullet = .501" (12.74 mm)

Product Type: .50" bullet, lead, with molded plastic sabot.
Size: 12-gauge sabot with 332 grain lead bullet 
Type: Expansion-point

*Industry-accepted tolerances apply to all weights and measures.

WARNING: When loading slug components with an inherent gas seal, the entire slug component must be nudged down with your reloading press' rammer tube. Many loaders complain that they don't have enough room for a crimp. This tells us that the reloader is NOT pushing down on the slug prior to crimping and thus not properly seating the slug on the powder. Depending on your loading tool, these loads may require a series of nudges to allow the powder to enter and fill the concave (cupped) plastic gas seal. If you don't do this, then you'll get the "no-fit" problem or a failed load when the powder refuses to fully ignite. Burned or punctured gas seals is almost always a result of this user error.

Made in Turkey