Lee 16ga Load-All II

The Lee Load-All is an entry-level loading tool without a big investment. It is an inexpensive tool that is intended for starters or low-volume loading. It is not meant for high-volume production or for very complex, multi-component handloads. This is a good low-cost way to become familiar with the rudiments of shotshell handloading.

Life and reloading is all about expecations: Expect to load only simplistic shotshell loads with this tool. Do NOT expect to load complex hunting loads or load in new/primed hulls that have not been previously crimped. If you are loading new hulls, then you may want to use a Roll Crimper and an Overshot Card to complete your crimp. Why are we telling you this? The reason is that our technical department is often assisting customers who want a solution that does not exist. We urge you to buy a tool that is adequate for your specific loading task. No single tool can do everything. If you have questions, please call us before you buy.

• Press Type: Single-Stage handloading tool  
• Available gauges: 12ga, 16ga or 20ga (sold separately) 
• Shell Length: 2-3/4" or 3" only
• Frame Material: Steel frame, plastic base
• Priming Feature: Single primer loading. The operator must place the primer in the press.

Accessories:

• Comes with 6 and 8 point crimp starters
• Safety charge bar
• Steel sizing ring 
• Aluminum plate for primer catcher 
• Spare wad guide 
• Primer guide 
• Spring and pin 
• One screw and two bolts with locking nuts

• Note: this press can NOT load 2-1/2" or 3-1/2" shotshells

Charge Bar Shot Weight: Comes with 8 shot bushings

• Bushings included measure 7/8, 1, 1-1/8, 1-1/4, 1-1/2, 1-3/4 and 1-7/8 ounces

Powder Bushings Included: 

• Bushing measure 095, 100, 105, 110, 116, 122, 128, 134, 141, 148, 155, 163, 171, 180, 189 and 198 cubic centimeters